Static structural analysis for rotating wheel

Oh! I'm really sorry for the mistake (I saw static analysis at the 2.19" of the previous video).
Sorry I can't help you I'm only a beginner, I've to learn the Eficas module yet.

Hi, sorry for disturbing, but I would like to specify:
you wrote that it is possible with code-aster, did you mean to make simulation for rotation body?
ie if I need to find stress (stess value) for whell made from steel and rotating at 1000 RPM - I have to use ASTK?
Thank you!

keeswouters wrote: Hoi ZachJa

you can use ''Aster-inside-Salome'' (CAELinux) but you can also run it ''stand alone''.
''Aster-inside-Salome'' is probably easier to start with and at sometime it may be restricted in command you can apply within your command file.
C-Aster with ASTK is more ''flexible'' and hence a sligthly more difficult to use to start with.
But finally it is your choice.

Thank you for reply.

I made step model of wheel (Douts 0.25 m). Exported into Salome. Added surface group "fix" (hole in the huh center). Made mesh. Added 100 rad/s rotation.
But when I start run simulation - it shows "simulation failure".
Could you please help me? What I am doing wrong?


rot1.png

rot1.comm

www.dropbox.com/s/589gsq9a44jx31m/rot1.comm?dl=0
www.dropbox.com/s/m5sqlp7k86su2jc/rot1.png?dl=0

Thank you.

I made step model of wheel (Douts 0.25 m). Exported into Salome. Added surface group "fix" (hole in the huh center). Made mesh. Added 100 rad/s rotation.
But when I start run simulation - it shows "simulation failure".
Could you please help me? What I am doing wrong?

www.dropbox.com/s/m5sqlp7k86su2jc/rot1.png?dl=0
www.dropbox.com/s/589gsq9a44jx31m/rot1.comm?dl=0