Error in Computing Mesh -Memory allocation problem
- Jake Zwart
- Topic Author
- Offline
- New Member
-
Less
More
- Posts: 13
- Thank you received: 1
12 years 7 months ago #6255
by Jake Zwart
Error in Computing Mesh -Memory allocation problem was created by Jake Zwart
When I try to mesh the piston in the in the tutorial /opt/caelinux/docs/tutorials/Piston_tutorial.pdf I am running into problems with meshing.
I follow the tutorial step by step and all goes well until I get to the mesh generation section and try to compute the mesh. Then a popup comes up that says Mesh Computation failed. The error is a Memory Allocation Problem.
Other information:
OS Running CAELinux 2011 from USB flash drive.
The imported piston is named piston, not piston.stp_1
I follow the tutorial step by step and all goes well until I get to the mesh generation section and try to compute the mesh. Then a popup comes up that says Mesh Computation failed. The error is a Memory Allocation Problem.
Other information:
OS Running CAELinux 2011 from USB flash drive.
The imported piston is named piston, not piston.stp_1
- Claus
-
- Offline
- Moderator
-
Less
More
- Posts: 670
- Thank you received: 34
12 years 7 months ago #6256
by Claus
Code_Aster release : STA11.4 on OpenSUSE 12.3 64 bits - EDF/Intel version
Replied by Claus on topic Re: Error in Computing Mesh -Memory allocation problem
You should increase element size so you don't run out of memory - alternatively close down everything that uses RAM while you mesh.
How much RAM have you got? The piston example shouldn't require that much.
/C
How much RAM have you got? The piston example shouldn't require that much.
/C
Code_Aster release : STA11.4 on OpenSUSE 12.3 64 bits - EDF/Intel version
Moderators: catux
Time to create page: 0.113 seconds