coarse mesh
- rui simoes
- Topic Author
- Offline
- Senior Member
Less
More
- Posts: 48
- Thank you received: 0
13 years 10 months ago #4318
by rui simoes
coarse mesh was created by rui simoes
hi all,
how can one coarse regions of an already computed mesh?
is it possible, is there a command for that?
greetings
rui
how can one coarse regions of an already computed mesh?
is it possible, is there a command for that?
greetings
rui
Please Log in or Create an account to join the conversation.
- kwou
- Offline
- Moderator
13 years 10 months ago #4321
by kwou
Interest: structural mechanics, solar energy (picture at 'my location' shows too little pv panels)
--
kind regards - kees
Replied by kwou on topic Re:coarse mesh
Hoi Rui
as far as I know you cannot do that (other than using Salome and trying with a coarser setting of whatever parameter).
Within Code Aster you can use Homard to refine your mesh depending on certain criteria, but of course, that is exactly the other way around.
kind regards - kees
as far as I know you cannot do that (other than using Salome and trying with a coarser setting of whatever parameter).
Within Code Aster you can use Homard to refine your mesh depending on certain criteria, but of course, that is exactly the other way around.
kind regards - kees
Interest: structural mechanics, solar energy (picture at 'my location' shows too little pv panels)
--
kind regards - kees
Please Log in or Create an account to join the conversation.
Moderators: catux
Time to create page: 0.118 seconds