printing INF & SUP stresses at once?
- Borja AP
- Topic Author
- Offline
- Junior Member
-
Less
More
- Posts: 21
- Thank you received: 0
14 years 1 month ago #5389
by Borja AP
printing INF & SUP stresses at once? was created by Borja AP
Hello!
I am wondering if is there any way to print the Von Mises stresses of the INFerior SUPerior layers of an externally pressurised cylinder, made of shell elements, all at once on the same mesh? I've seen it in some commercial softwares and I find it quiet useful when checking the levels of stresses.
Thanks to everybody.
I am wondering if is there any way to print the Von Mises stresses of the INFerior SUPerior layers of an externally pressurised cylinder, made of shell elements, all at once on the same mesh? I've seen it in some commercial softwares and I find it quiet useful when checking the levels of stresses.
Thanks to everybody.
- kwou
-
- Offline
- Moderator
-
14 years 1 month ago #5391
by kwou
Interest: structural mechanics, solar energy (picture at 'my location' shows too little pv panels)
--
kind regards - kees
Replied by kwou on topic Re:printing INF & SUP stresses at once?
Hoi Borja
have a look here:
www.caelinux.org/wiki/index.php/Contrib:KeesWouters/shell
kind regards - kees
have a look here:
www.caelinux.org/wiki/index.php/Contrib:KeesWouters/shell
kind regards - kees
Interest: structural mechanics, solar energy (picture at 'my location' shows too little pv panels)
--
kind regards - kees
- kwou
-
- Offline
- Moderator
-
14 years 1 month ago #5392
by kwou
Interest: structural mechanics, solar energy (picture at 'my location' shows too little pv panels)
--
kind regards - kees
Replied by kwou on topic Re:printing INF & SUP stresses at once?
sorry - resend the message once again.<br /><br />Post edited by: Kees Wouters, at: 2011/03/21 20:13
Interest: structural mechanics, solar energy (picture at 'my location' shows too little pv panels)
--
kind regards - kees
- Borja AP
- Topic Author
- Offline
- Junior Member
-
Less
More
- Posts: 21
- Thank you received: 0
14 years 1 month ago #5397
by Borja AP
Replied by Borja AP on topic Re:printing INF & SUP stresses at once?
Hei Kees
Thanks again for your fast reply I am following your tutorial for instance, but What I really mean is if is there any way to print over the sup/exterior layer of the mesh the sup-stresses while doing so with the inf-stresses on the inferior/interior side of the mesh at once.
Thanks again for your help.
Thanks again for your fast reply I am following your tutorial for instance, but What I really mean is if is there any way to print over the sup/exterior layer of the mesh the sup-stresses while doing so with the inf-stresses on the inferior/interior side of the mesh at once.
Thanks again for your help.
Moderators: catux
Time to create page: 0.176 seconds