problems solving with aster - piston tut

Firstly a huge thanks to the developpers for bringing Salome and Aster together!

Im following the piston tutorial, but when I get to the solving - things grind to a halt. I have attached the console output here:

pastebin.org/28566

Exporting to ASTK produces the error: 'job limited to s'

Please tell me what else to post as im very new to Salome-meca

Thanks in advance

reading another post i tried to disable 'interactif' - but the only thing i could find, was 'interactive followup on/off' which i switched off - this produces a syntax-error.

I can find nowhere to change 'mode = interactif' to something else - what am i doing wrong?

pastebin.org/28588 <- heres the console output with some fort.80 not found errors

Im losing my hair here

Thx in advance.

Hello,

The message 'job limited to s' probably means that you have exceeded the reserved CPU time for the solution: to change the maximum CPU time, just edit your Code-Aster Case in Salome and set CPU time to some large value (in seconds) like 10000. In ASTK, this parameter is at the top right of the interface.

Try this and if it does not solve the problem, please report the .mess file generated by Aster. It contains all the execution log!!

Regards,


Joël Cugnoni

Hi again - thx for helping

If I set the time to something like 1000 - I get a 'value out of range'

I run the latest script created in flasheur, this produces the following .mess file
nothing else does.

pastebin.org/28717

edit: once again, here is the console output, this time running SALOME-MECA as root:

pastebin.org/28719

Post edited by: Claus, at: 2008/04/10 13:41