Complex strain in dynamic analysis
- Hugo
- Topic Author
- Offline
- New Member
-
Less
More
- Posts: 5
- Thank you received: 0
10 years 10 months ago - 10 years 10 months ago #7657
by Hugo
Complex strain in dynamic analysis was created by Hugo
FRF.zip
Hello,
I'm performing a simulation (attached folder) to obtain the frequential response of a mechanical system. (complex response)
After this I 'CALC_ELEM' the strain 'EPSI_ELNO' on the surface 'SUPPORT' (4 datas 'EPXX','EPYY','EPZZ','EPXY' because QUAD4) and I would like to combine with the strain 'EPSI_ELNO' of the volume 'VPIEZO' to obtain for the corresponding QUAD4 of 'SUPPORT' the 6 datas 'EPXX','EPYY','EPZZ','EPXY','EPXZ','EPYZ'.
Also the 'EPSI_ELNO' are written for the local references of the element but I would like to have these datas in the global references. Do you think it's possible?
What about the 'EPSG_ELNO' what's the point of this strain? When I try to obtain them I have an error:
Moreover I would like to insert these strains in table but it seems that it's not possible, does it?
Thank you.
Sincerely,
H.B.
compo.txt
Plaque_complete.txt
Hello,
I'm performing a simulation (attached folder) to obtain the frequential response of a mechanical system. (complex response)
After this I 'CALC_ELEM' the strain 'EPSI_ELNO' on the surface 'SUPPORT' (4 datas 'EPXX','EPYY','EPZZ','EPXY' because QUAD4) and I would like to combine with the strain 'EPSI_ELNO' of the volume 'VPIEZO' to obtain for the corresponding QUAD4 of 'SUPPORT' the 6 datas 'EPXX','EPYY','EPZZ','EPXY','EPXZ','EPYZ'.
Also the 'EPSI_ELNO' are written for the local references of the element but I would like to have these datas in the global references. Do you think it's possible?
What about the 'EPSG_ELNO' what's the point of this strain? When I try to obtain them I have an error:
!------------------------------------------------------------------------------!
! <EXCEPTION> <CALCULEL2_29> !
! !
! la grandeur associée au champ DYNAHARM.001.000000 : DEPL_C !
! n'est pas celle associée au paramètre PDEPLAR : DEPL_R (option: EPSG_ELNO !
!------------------------------------------------------------------------------!Moreover I would like to insert these strains in table but it seems that it's not possible, does it?
Thank you.
Sincerely,
H.B.
compo.txt
Plaque_complete.txt
Last edit: 10 years 10 months ago by Hugo.
Moderators: catux
Time to create page: 0.121 seconds