using openfoam helyx os
- Joseph
- Topic Author
- Offline
- New Member
- CAE Engineer
Less
More
- Posts: 8
- Thank you received: 0
9 years 8 months ago #7987
by Joseph
using openfoam helyx os was created by Joseph
Anybody out there using Helyx os on CAELinux? I'm trying to run circuitboardcooling tutorial example, but blockmesh the case and view mesh in helyx os I only see box no board inside. Any help would be appreciated.
- Joseph
- Topic Author
- Offline
- New Member
- CAE Engineer
Less
More
- Posts: 8
- Thank you received: 0
9 years 7 months ago #7997
by Joseph
Replied by Joseph on topic Re: using openfoam helyx os
I'm also considering upgrading to Helyx -OS 2.2 but not sure if it will work with OpenFOAM 2.1 installed.
- Joseph
- Topic Author
- Offline
- New Member
- CAE Engineer
Less
More
- Posts: 8
- Thank you received: 0
9 years 5 months ago #8087
by Joseph
Replied by Joseph on topic Re: using openfoam helyx os
Successfully, installed Helys-os 2.2 and OpenFOAM 2.3.1 with Paraview 4.1 along side the versions that came with CAE linux, but still looking to traverse the 'learning curve' for these softwares.
- Claus
- Offline
- Moderator
Less
More
- Posts: 670
- Thank you received: 34
9 years 5 months ago #8088
by Claus
Code_Aster release : STA11.4 on OpenSUSE 12.3 64 bits - EDF/Intel version
Replied by Claus on topic Re: using openfoam helyx os
HelyxOS makes it somewhat easier, but I agree with you about the learning curve; I wonder if I'll ever make a dedicated effort to traverse it as you say
/C
/C
Code_Aster release : STA11.4 on OpenSUSE 12.3 64 bits - EDF/Intel version
Moderators: catux
Time to create page: 0.157 seconds